Drip edge installation
The metal at the roof edge
Water travels along rafters and decking before it shows on a ceiling, so the stain is rarely underneath the hole. Tracing the real entry point is most of the work on a leak call and the part that separates a repair that holds from one that fails at the next storm. Done properly it means time in the attic with a moisture meter, not a guess from the driveway — and where the entry point genuinely will not reveal itself, a controlled water test on the suspected area to reproduce it.
Dooly County is far enough south to take the inland remnants of Gulf and Atlantic hurricane systems, and that is the storm profile that matters here. By the time these systems reach Dooly County the wind has dropped below the headline numbers but is still sustained for hours, which does something different to a roof than a short violent gust — it works shingle tabs loose over an extended period and drives rain horizontally under courses that would shed a normal downpour. The heat and humidity do the rest. Roofs here run hot for most of the year, which ages the shingle and hardens every rubber and sealant component, and the humidity means anything that gets wet inside the roof stays wet.
Usually. Staining patterns, moisture readings and the physical condition of flashing and boots tell most of the story. Where that is not conclusive, a controlled water test on the suspected area reproduces it without waiting for weather.
Almost always because the patch went where the stain was rather than where the water entered. Water can travel several feet along a rafter before it drops. Sealing the visible end does nothing about the gap further up the slope.
The metal at the roof edge
Single-ply flat roof membrane
Bruising and granule loss
Lifted tabs and broken seals
Clearing, repair and replacement
Vinyl, fiber cement and wood
You will get a straight answer on whether Dooly County needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (229) 592-0097